It’s been a while we didn’t post anything in here…  Anyway, here is a picture to announce that the music video we made can be watched on MTV Schweiz and some public tv channels in Switzerland. Yay. We will post the video on our website pretty soon.

Happy new year!
Don’t forget to check the video!

The idea was to reinterpret Andy Wahrol’s Dreamachine with nowadays possibilities. In projection technologies, not in drugs

Therefore, we decided to build a projector stand with a 45 degrees mirror in front of it. The mirror sould be able to rotate on 360 degrees, and had to be controled by the computer projecting the image.

Now we have to find a good stepper motor.
I started opening an old floppy, and an old Zip drive.

But the data sheets were to hard to find, so i finally decided to use this one because it was the same used in Epfl’s e-puck robots, witch is open source, so it was easy the find to drive sequence for this engine.
All I need now was to find a driver. I found a very usefull tutorial by Juan Manuel González on controling a stepper motor with the Wiring Board on his website, and I chose to use the same driver, the L293D.

Then I wrote the following driving sequence:

void forward(){
digitalWrite(0, HIGH);
digitalWrite(1, LOW);
digitalWrite(2, HIGH);
digitalWrite(3, LOW);
delay(time);
digitalWrite(0, LOW);
digitalWrite(1, HIGH);
digitalWrite(2, HIGH);
digitalWrite(3, LOW);
delay(time);
digitalWrite(0, LOW);
digitalWrite(1, HIGH);
digitalWrite(2, LOW);
digitalWrite(3, HIGH);
delay(time);
digitalWrite(0, HIGH);
digitalWrite(1, LOW);
digitalWrite(2, LOW);
digitalWrite(3, HIGH);
delay(time);
}


And here is the first test:

View the test video